Install Instructions for JLTMC-GT500-20

Before You Start

Please read the entire product guide before proceeding.

Ensure all parts are present.

If you are missing any of the components, call our customer support at (909) 947-0015.

Do not work on your vehicle while the engine is hot.

Make sure the engine is turned off and the vehicle is in Park and the Parking Brake is set.


JLT Performance Inc. makes no warranties whatsoever, expressed or implied, oral or written to any purchasers, except the warranty above. JLT Performance Inc. hereby specifically excludes from any implied warranty of merchantability or implied warranty of incidental, secondary, or consequential damages of any kind whatsoever. All purchasers and users of products manufactured by JLT Performance Inc. agree to hold harmless and indemnify JLT Performance Inc. from any and all claims arising from their use. Failure to receive notice of any or the limitations contained in this disclaimer shall not serve to extend liability to JLT Performance Inc. for any claims arising out of use of its products.




Required Tools

Note: Approximate Install Time: 1 Hr

STEP 1

Using a flat screwdriver remove the 2 factory pins on the cowl panel.

STEP 2

Remove the protective film from the Velcro strip and place it on the rear of the flat area shown below. 

STEP 3

Line up with the holes in the cowl and install pins. Insert supplied push pin in hole by fender. Press firmly to adhere the Velcro strip.